This is the Home of Olight Technologies
TorchSA is the sole distributors of Olight.
BLF GT Kit
The world's best production thrower ever build.
9 Item Items
Warning: Last items in stock!
The BLF GT Kit comes with a charger and Batteries valued at R3500
By default the GT firmware is set to suit most users and applications, but several settings are user-configurable. To enter the configuration settings, press&hold the button for about 8 s (3 s if in the MODE-SET UI), do not release until a double flash followed by a single blink is seen. The single blink is the prompt for the first setting. Click the button as many times as required for that setting, or leave the setting alone and simply wait for the next double flash, this time followed by two blinks, indicating that we are now at setting #2, etc.
The GT confirms each click with a blink. A press&hold skips to the next setting. A continuous press exits the setup menu completely. Four blinks indicate that the setup is completed.
The available settings differ, depending if the GT is currently set to the RAMPING UI or the MODE-SET UI. Note that changing setting 1 flips to the other UI and immediately kicks you into the table for that UI:
>1 Mcd (ANSI throw >2000 m)
Tom E’s open-source NarsilM v1.2
 By default the GT is set to use the very intuitive Narsil smooth RAMPING UI. Instant access to a 2.5 A TURBO mode is also provided.
 A more conventional discrete level MODE-SET UI is available as an alternative. Any one of 12 pre- defined mode-sets can be selected.
 MOMENTARY mode is useful for signaling purposes or rapidly/briefly lighting up targets.
Four or eight button-top 18650 cells (4S1P or 4S2P). Protected cells are recommended. Cells are not included.
35 W, 2.5 A regulated buck driver with conversion efficiency that exceeds 90%. Parasitic drain while OFF is ~150 μA (~250 μA with button back-light on).
118 mm ID, aluminum, smooth finish
Glass with anti-reflective coating
Aluminum with Type III hard-coat anodizing
Standard 1/4 inch threaded (1/4-20 UNC)
Tactile with back-lit rubber boot
Equivalent to IP65, do not immerse in liquids
Approximately 1.8 kg without cells
135 mm Ø head x 315 mm length
|Dimensions||135mm x 315mm|
|Compatible Batteries||18650 3500mAH 10A|